FAQs

FAQ Article filter
What Is the Best Cleaning Solvent for an Ultrasonic Process?
If the chemistry is a good solvency match to the soil, less sonic agitation will be needed. This allows you to run your cleaning process more quickly, at lower temperature, and lower amplitude, decreasing next...
Read More

How Do You Maximize Cleaning Performance with Ultrasonic Equipment?
Several adjustments can be made to increase the cleaning performance of your ultrasonic process: 1) Frequency – This is the number of waves in a second, so how “tight” the wave form is. next...
Read More

How Does Ultrasonic Equipment Work?
An ultrasonic cleaning process utilizes equipment to transmit ultrasound waves, generally between 20-40 kHZ. The transducers send those sound waves through the liquid cleaner, which acts as a transfer next...
Read More

Which wipe is best with aggressive solvents?
Solvent compatibility is another factor to consider when choosing a wipe. If the wipe is to be used with a solvent in the cleaning application, then the wipe must be selected with the solvent in mind. next...
Read More

What wipe is best for rough surfaces?
Any wipe will produce particulates depending on the amount of abrasion it receives in use, so abrasion resistance should be considered. Wipes usually release the most particulates from their edges, so next...
Read More

Which wipe is best for general cleaning?
Techspray general purpose wipes (e.g. Blue Maintenance Wipes #2365-300) are meant to be used for wiping and in non-critical or controlled environments. By cleanroom standards, Techspray general purpose next...
Read More

What type of wipe is best for cleanrooms?
Cleanroom wipes used for critical applications are almost always knitted synthetic fibers. Knitted polyester fabric, like used for Techclean Purwipe (part #2355-100), is the most popular wipe material next...
Read More

Can I solder directly onto a drawn trace?
A trace drawn with the conductive ink will combine with solder, provided the soldering temperature does not exceed 350°F (177°C) and the solder joint is formed within 5 seconds. If the drawn trace next...
Read More

How do I prepare the surface for trace repair?
For optimal adhesion to most surfaces, clean the repair area prior to ink application. That insures the surface is free of oil, greases and handling soils. For precise cleaning just around the rework area, next...
Read More

How do I unclog a conductive pen?
If you experience difficulty in producing a smooth flow of conductive ink, this could indicate clogging of the product outflow channel within the tip assembly. As the pen sits in storage, especially if next...
Read More

You did not finish submitting your information to request a sample