How do you use an aerosol conformal coating? (2106-12S) - Banner

How do you use an aerosol conformal coating? (2106-12S)

Shake well. SURFACE MUST BE CLEAN & MOISTURE FREE. Areas not requiring coating should be masked. Coating:  Spray top to bottom, allowing coating to flow around components. Rotate board 90˚ and repeat process 2 or more times.  If nozzle clogs, clean with solvent or use new nozzle. Cure:  A 1.0 mil coating will be tack-free in 45 minutes.  Full cure requires 24 hours @74˚F/23˚C. Heat Cure: 15 minutes @120˚F/49˚C. An open vessel of water placed in the drying chamber will facilitate curing. UV detectable for QC inspection. Removal: Coating may be removed by soaking in Conformal Coating Remover. Use TraceTech™ Conformal Coating Remover Pen for spot removal. After the new component is installed, areas should be cleaned and re-coated.


Stay up-to-date on Techspray news, products, videos & more.

Previous Article
You did not finish submitting your information to request a sample